Recording

You record from a keyboard or another MIDI instrument connected to the Mac, on one channel at a time.

Recording

  1. In the Arrange click R on the channel you want to record on: it becomes the record-enabled channel. If you don't enable one, Record uses the selected channel.
  2. Put the cursor where you want to start and, if you need it, choose a Precount of 1 or 2 bars.
  3. Press Record (⌥-Space). What you play during the precount is not recorded.
  4. Press Stop: everything you played goes into the song as a single change, which ⌘Z removes.

While recording, a red band grows in the channel row. Notes (with release velocity), controllers, pitch bend, aftertouch and program changes are recorded, on the row's channel whatever channel they come from.

Modes

  • Mix adds what you play to the existing notes.
  • Replace deletes what was there in the recorded range.
  • Punch In and Punch Out record only from L and up to R.
  • With Cycle on, each pass is added (Mix) or replaces the last pass (Replace). A note held past R ends at R.
  • Transport › Input Quantize quantizes the notes while you record them, with the Quantize value in the toolbar.

MIDI Thru

With Transport › MIDI Thru on (the default) what you play is heard on the output of the record-enabled channel, with its instrument. Which inputs to listen to and which messages to let through is chosen in Settings.

Step input

To enter notes one at a time, without timing, from the Piano Roll or the Drum Editor:

  1. Turn on the Step Input checkbox in the toolbar and put the cursor where to start.
  2. Play a note: it goes to the cursor, as long as the Quantize value (in the Drum Editor the row step), and the cursor moves on. A chord stays at the same position and the cursor moves on when you release the keys.
  3. → moves one step without a note (a rest); ← goes back one step and deletes the notes placed there.